| Problem Document
|
Former IBIS ID
|
Synopsis
|
Last Modified Date
|
| 1456194.1 |
|
Sun Fire [TM] V1280/E2900, Netra 1280/1290 ( LW8/Amazon/Everglades ): net1 Onboard Interface fails on boot net1 and test net1 of interface |
2012-05-08
|
| 1453917.1 |
|
On lw8 systems (V1280, E2900, Netra 1280, Netra 2900) lom>console command may return that Solaris is not active when Solaris is actually running |
2012-05-02
|
| 1399165.1 |
|
Sun Fire [TM] V1280/E2900, Netra 1280/1290: Troubleshooting LOM can't boot - PANIC No ID info + busyWait() timeout + MAC address 0:0:0:0:0:0 |
2012-09-04
|
| 1269395.1 |
|
Sun Fire[TM] V1280, E2900, Netra[TM] 1280, and 1290 Servers: IB_SSC fails POST after "Not enough memory" message |
2011-11-16
|
| 1019667.1 |
243326 |
Sun Fire[TM] Server System Board (SB) voltage errors. |
2012-08-06
|
| 1018148.1 |
229498 |
Sun Fire[TM] Server: Problems Installing a DAT Drive in a V1280, Netra[TM] 1280 or E2900 |
2010-07-20
|
| 1017987.1 |
229265 |
Response to error: SepromSegment(constructor): PE at 0x----: Invalid CRC observed=xxxxxxxx expected=yyyyyyyy |
2012-07-30
|
| 1017844.1 |
229081 |
Sun[TM] Fire 3800/4800/4810/6800/E2900/E4900/E6900/V1280 and Netra[TM] 1280/1290 Server: I/O Board (IB) power supply failures. |
2012-07-30
|
| 1017580.1 |
228732 |
Using "cfgadm -c configure" and diag-level=mem2 may fail on Sun Fire[TM] V1280 and Netra[TM] 1280 |
2012-07-30
|
| 1012344.1 |
217032 |
PRTDIAG output incorrect after reseating power supplies. |
2012-07-31
|
| 1010901.1 |
215041 |
Installation of Solaris[TM] 9 04/04 or Solaris[TM] 10 causes domain to panic or ERROR Fast Data Access MMU Miss |
2012-07-30
|
| 1010536.1 |
214485 |
Sun Fire[TM] V1280, E2900, Netra[TM] 1280, and 1290 Servers: Programming LOM Failed with Error: Resource Temporarily Unavailable |
2011-12-20
|
| 1009696.1 |
213337 |
"kstat -p" and "prtdiag -v" may give seemingly different PCI bus speeds for Dual Fast Ethernet and Dual SCSI PCI Adapters |
2012-07-30
|
| 1009648.1 |
213283 |
Sun[TM] Fire 3800/4800/4810/6800/E2900/E4900/E6900/V1280 and Netra[TM] 1280/1290 Server: SepromContainer.writeOut: sun.serengeti.I2cException: verify error |
2012-07-30
|
| 1009467.1 |
213078 |
How to clear faults in FMA after component replacement on Sun Fire[TM] servers. |
2012-07-30
|
| 1009008.1 |
212426 |
Sun Fire[TM] 3800, 4800, 4810, 6800, E4900, E6900, V1280, E2900, Netra 1280, or 1290 server: NCPQ_TO workarounds |
2012-07-30
|
| 1008672.1 |
211889 |
Sun Fire[TM] (3800-6800/E2900-E6900/v1280) Server: System Controller Setdate to Daylight Savings Time |
2010-07-06
|
| 1007996.1 |
211030 |
picld error after upgrading PCI IB_SCC IO Assembly to PCI+ IO Assembly |
2012-07-30
|
| 1006676.1 |
209307 |
Sun Fire[TM] V1280, E2900, or Netra 1280, 1290: a Solaris[TM] shutdown followed by a lom poweroff and poweron sequence can cause an unplanned SC reset. |
2012-01-20
|
| 1005021.1 |
207042 |
Sun Fire[TM] V1280/E2900/Netra[TM] 1280 Server: Incorrect Firmware Upgrade Procedure Can Lead to Incompatible Firmware on System Boards |
2011-12-20
|
| 1005013.1 |
207032 |
probe-scsi-all may fail without reset-all on all Sun[TM] Systems |
2012-07-30
|
| 1004868.1 |
206830 |
SunFire[TM] V1280, E2900 and Netra[TM] 1280, 1290: Lights Out Management (LOM) packages are missing |
2012-07-30
|
| 1004771.1 |
206623 |
Sun Fire[TM] V1280/Netra 1280: prtdiag command fails for non-root user with error message:" picl_initialize failed: General system failure" |
2012-07-30
|
| 1004679.1 |
206485 |
Sun Fire[TM] Servers: setdefaults does not reset local-mac-address? parameter |
2010-10-18
|
| 1004364.1 |
206035 |
Sun Fire[TM] Midrange Server: Safari Port Error may be caused by a resetting SC |
2012-01-26
|
| 1003661.1 |
205172 |
How to recover when a Sun Fire[TM]E2900, V1280 or Netra[TM] 1280 has an incompatible RTOS and ScApp |
2011-11-22
|
| 1003458.1 |
204845 |
JumpStart[TM]: How to disable ce Ethernet autonegotiation for boot net |
2012-05-23
|
