Sun Microsystems, Inc.  Sun System Handbook - ISO 4.1 October 2012 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Asset ID: 1-72-1010536.1
Update Date:2011-12-20
Keywords:

Solution Type  Problem Resolution Sure

Solution  1010536.1 :   Sun Fire[TM] V1280, E2900, Netra[TM] 1280, and 1290 Servers: Programming LOM Failed with Error: Resource Temporarily Unavailable  


Related Items
  • Sun Netra 1280 Server
  •  
  • Sun Fire V1280 Server
  •  
  • Sun Fire E2900 Server
  •  
Related Categories
  • PLA-Support>Sun Systems>SPARC>Enterprise>SN-SPARC: Exx00
  •  
  • .Old GCS Categories>Sun Microsystems>Servers>Entry-Level Servers
  •  
  • .Old GCS Categories>Sun Microsystems>Servers>Midrange Servers
  •  
  • .Old GCS Categories>Sun Microsystems>Servers>Midrange V and Netra Servers
  •  

PreviouslyPublishedAs
214485


Symptoms
When updating the firmware, flashupdate or lom -G may error with:
Programming LOM(Lights Out Management) failed with error: Resource temporarily unavailable
Example situation:
The following example show the "lom -G" method for updating system firmware, but this can also take place utilizing "flashupdate".  This example was from a Sun Fire[TM] v1280 system where the update failed during the update of the cpu/mem boards:
# lom -G lw8cpu.flash
This program will replace LOM firmware with version 5.17.0
Are you sure you want to continue?
Enter 'C' and return to Continue or anything else to Terminate
C
Programming LOM(Lights Out Management) failed with error: Resource temporarily unavailable
#


Resolution
To avoid the failure message, you might need to reset the system controller (SC) and retry the flash.
The following example utilizes ScApp version 5.17.x, but it is suggested that you maintain the most recent version of ScApp (which is 5.20.x and is available via patch 114527).

Prior to beginning the firmware update procedure reset the SC:
lom> resetsc -y
1. Upgrade the firmware on the SC: 
# lom -G sgsc.flash
# lom -G sgrtos.flash
2. Escape to lom> by entering the following:
# .
3. Reset the SC: 
lom>resetsc -y
4. After you reset the SC, proceed with upgrading the boards in the system: 
# lom -G lw8cpu.flash
# lom -G lw8pci.flash
5. Escape to lom> again, shutdown the system, and then power everything on again.
lom>shutdown
lom>poweron
(Note:  The shutdown command shuts down the Solaris[TM] Operating System, so make sure the server is ready to be unavailable for the duration of the shutdown and poweron steps)

If the resetsc step is not performed you will not be able to finish the procedure without a problem.  If you did perform the reset, and you still receive the "Resource temporarily unavailable" error message then try resetting the SC once again. This should allow you to avoid the error message.


Product
Netra 1280 Server
Netra 1290 Server
Sun Fire V1280 Server
Sun Fire E2900 Server

Internal Comments
v1280, 2900, 1280, 1290, firmware, lom, Resource Temporarily Unavailable, Programming LOM Failed, Error, lom -g, flashupdate, resetsc, scapp, normalized

Attachments
This solution has no attachment
  Copyright © 2012 Sun Microsystems, Inc.  All rights reserved.
 Feedback