Technical support is supplied by ATL/Quantum in EMEA and the Americas; Sun provides support in all other locations.
This section provides the most common repair procedures for the
L3500 tape library. The repair procedures are provided in the following manual:
The table below provides the page numbers that each procedure begins on.
|
Component
|
Page Numbers
|
Tips
|
|
Cosmetic Panels
|
90-94
|
|
|
Controller Electronics Assembly
|
95-97
|
|
|
X-Axis Interconnect Board
|
99-101
|
|
|
X-Axis Stepper Motor Assembly
|
102-103
|
|
|
X-Axis Stepper Motor Assembly
|
104-106
|
|
|
Load Port Door Lockout Solenoid
|
107-109
|
|
|
Front Door Interlock Switch
|
110-111
|
|
|
Y-Axis Umbilical Cable
|
112-113
|
|
|
X-Axis Umbilical Cable
|
114-115
|
|
|
X-Axis Drive Belt
|
116-117
|
|
| Y-Axis Drive Belt |
118-120
|
|
| DC Fan Assembly |
121-125
|
|
|
Extension Axis Assembly
|
126
|
|
| Tape Drive |
127-129
|
Information from the following FINs may be helpful when replacing a tape
drive:
- I0495
- Broken door handles on DLT7000s
- I0448
- Leader misalignment may cause problems
- I0435
- st.conf entries for 2.5.1 & 2.6 are incorrect
- I0349
- Internal cables missing from 2 drive library models, can't add additional
drives without them
Quantum DLT7000 tape drives may fail with right column of LEDs flashing (FCO
A0150-1).
|
| Tape Drive Interface Board |
130-131
|
|
| Tape Drive Stepper Motor Assembly |
132-133
|
|
| Tape Drive Tray Assembly |
134-135
|
|
| Tape Drive Distribution Board |
136-137
|
|
| Tape Drive Mulitplexor Board |
138-140
|
|
| Control Panel Assembly |
141-142
|
|
| X-Axis Confirmation Sensor |
143-144
|
|
| Robotics Controller Board |
145-147
|
|
| Actuator Driver Board |
148-150
|
|
| PC Logic Power Supply (326 Watt) |
151-153
|
|
|
Motor Power Supply (100 Watt)
|
154-156
|
|
| Light Bulb |
157-158
|
|
| Reassembling Library |
159-160
|
|
