This section provides the most common repair procedures for the
6020/6120. The repair procedures are provided in the following manual:
The table below provides the section and page number that each procedure begins
on.
|
Component
|
Tips
|
|
Array Controller
|
-
Minimum supported releases for the Sun StorageTek T3+, 6120, 6320 and 6920.
(FAB 1000787.1).
|
| Controller Card |
- Sun StorEdge 6120 Arrays and 6320 Systems may reset due to a Controller
Board SRAM timing issue (FIN I1043-2).
|
| Disk Drives |
-
Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected
outages due to a spindle motor issue (FIN I1136-1).
- During power on (cold boot), one or more drives may come up in an
offline state (FIN I1009-2)
- Seagate Cheetah 7 146GB FC-AL and 73 GB FC-AL disk drives
may experience higher than expected failure rates due to
spindle motor failure (FCO A0256-1).
-
Seagate Cheetah 7 FC-AL and SCSI disk drives with serial numbers below 60000 are experiencing
a higher than expected failure rate due to a spindle motor issue (FCO A0239-1).
|
| Power Supply |
- StorageTek 6140 Family contains incorrect UL power supply
label (FAB 1019519.1).
|
| Power and Cooling Units |
- StorEdge 6020/6120 Arrays may automatically power themselves up after
being placed in standby mode (FIN I1002-1).
|
|
SAN Multiplatform Support
|
This site,  Sun Storage Networking provides information as follows:
- Multi-Platform Support Documents
- Get the Software
|
