SL8500 - Tools for SL8500 Library Installation

Asset ID:	1-75-1356348.1
Update Date:	2011-09-09
Keywords:

Solution Type Troubleshooting Sure

Solution 1356348.1 : SL8500 - Tools for SL8500 Library Installation

Applies to:

Sun StorageTek SL8500 Modular Library System - Version: Not Applicable and later [Release: N/A and later ]
Information in this document applies to any platform.

Purpose

Planning for a SL8500 installation. I need to know whether tools for installation should be ordered while ordering the SL8500 and if yes, what is the part number of tool set.

Last Review Date

September 7, 2011

Instructions for the Reader

A Troubleshooting Guide is provided to assist in debugging a specific issue. When possible, diagnostic tools are included in the document to assist in troubleshooting.

Troubleshooting Details

Tools are not ordered at the time of the library order. They are obtained/ordered just prior to the installation. There are 3 special "tools" that need to be at an installation besides basic hand-tools, step stool, etc. See details below:

1). Basic Installation toolkit with jacks to de-pallet and position the DEM and RIM frames. Many of these tool kits were distributed throughout the world to local departments. You cannot order this kit. You must locate a kit that resides in or near your area. The P/N of the kit is 24100250. It contains:

Description:
Copper rail connector extraction tool                                                              313921001
Frame jacks with handles                                                                               313880805
Tool bag                                                                                                        24100254
Torx screwdriver and bits                                                                               4850
3/8" drive ratchet wrench                                                                                3010420130
6" extension for 3/8" drive ratchet                                                                    3010420624
3/4" socket for 3/8" drive ratchet                                                                     24100036
3/8" socket for 3/8" drive ratchet                                                                     24100251
5/16" socket for 3/8" drive ratchet                                                                   3010420646
1/4" hex (Allen) on 3/8" drive                                                                          3010420645
5/16" hex (Allen) on 3/8" drive                                                                        3010420646
3/4" combination open end/box end wrench                                                     3010420417
5/8" combination open end/box end wrench                                                     24100253
25' tape measure                                                                                             3010420629
2' level                                                                                                             4100252
Feeler gauge set, to include a 0.010" gauge                                                      Obtain local
Rack alignment tool                                                                                          4198940xx
Rack stop tool kit                                                                                          4186449xx
Utility knife                                                                                                       4100045
Safety classes                                                                                                   4803
Wire side cutters                                                                                              24100041
Rubber mallet    3010420627
Serial cable for laptop    24100134
Crossover cable for laptop 24100163

2). The rack Alignment Bot P/N 419894002 is used to align the plastic racks on the rails. It is ordered from logistics several days before the installation and is returned to logistics after you are done using it.

3). Track Stop Installation Toolkit P/N 418644901 is used to install the new style double-lock track stops. It is ordered from logistics several days before the installation and is returned to logistics after you are done using it.
Attachments

This solution has no attachment