| Asset ID: |
1-71-1473436.1 |
| Update Date: | 2012-07-09 |
| Keywords: | |
Solution Type
Technical Instruction Sure
Solution
1473436.1
:
SL500 - How to open library door with power off
| Related Items |
- Sun StorageTek SL500 Modular Library System
|
| Related Categories |
- PLA-Support>Sun Systems>TAPE>Tape Hardware>SN-TP: SL500 Library
|
In this Document
Applies to:
Sun StorageTek SL500 Modular Library System - Version Not Applicable and later
Information in this document applies to any platform.
Goal
SL500 - How to open library door with power off
Please refer to SL500 Users Guide for complete instructions as seen below Part Number: E21059-03 April 2012, page 414
Fix
Open the Front Door (Without Power)
To open the front door when no library power exists, complete the following process.
Note – You must manually move the robotics park lever (beneath the facade and to the bottom left of the keypad) to the left position so that you can open the door with the key. Under normal conditions, the lever signifies that the robot is parked inside the robotics unit at the top of the library, and the door can be safely opened. When no power exists, the robot is not actually parked, but you will be able to open the door when you move the lever to the left.
1.Press the power switch on the back of the library to the OFF position.
2.Remove the robotic facade from the top of the library by gently pulling the facade from side to side to pull the ball studs away from the clips. You might have to use a screwdriver to gently pry it off.
Warning – Possible injury to finger. Make sure that your finger is completely to the left in the next step. Otherwise it could be pinched when the door locking lever extends as shown in the lower picture.
3.While using one hand to move the robotics park lever to the left, use your other hand to unlock the door with the key.
Attachments
This solution has no attachment
