Asset ID: |
1-71-1462375.1 |
Update Date: | 2012-10-04 |
Keywords: | |
Solution Type
Technical Instruction Sure
Solution
1462375.1
:
How to Remove and Replace a SPARC T6320 Service Processor:ATR:1462375.1:0
Related Items |
- Sun Blade T6320 Server Module
|
Related Categories |
- PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
|
In this Document
Applies to:
Sun Blade T6320 Server Module - Version Not Applicable and later
Information in this document applies to any platform.
Goal
How to Remove and Replace a SPARC T6320 Service Processor
********************************************************************************
To report errors or request improvements on this procedure,
please Add a Comment on Doc ID: 1462375.1
********************************************************************************
Fix
DISPATCH INSTRUCTIONS
The coin cell battery should be retrieved from your personal stock of coin cell batteries. If you have a battery, please cancel the part order and then accept the task. If you require this order to proceed, please do not cancel the part order and accept the task as normal.
WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
T6320 training is desirable but not required
TIME ESTIMATE: 30 minutes
TASK COMPLEXITY: 0
FIELD ENGINEER INSTRUCTIONS
PROBLEM OVERVIEW: SP failure
WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :
Shut Down the Oracle Solaris OS
Prepare the Server Module for Removal
Remove the Server Module From the Modular System
Remove the Cover
ESD Safety Measures
WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
Remove Service Processor
1. Pull back the plastic retaining tab and lift up on handle of the service processor card to release it from the bracket.
2. Grasp the top corners of the service processor and pull it out of the socket.
3. Place the service processor card on an antistatic mat.
4. Remove the system configuration PROM (NVRAM) from the service processor card and place the PROM on an antistatic mat.
Install Service Processor
1. Remove the replacement service processor from the package and place it on an antistatic mat.
2. Install the system configuration PROM that you removed from the faulty service processor.
The PROM is keyed to ensure proper orientation.
3. Insert the service processor edge into the bracket and carefully align the service processor so that each of its contacts is centered on a socket pin.
4. Push firmly and evenly between the handle edges, until the service processor is firmly seated in the connector socket.
5. Return the server module to operation.
OBTAIN CUSTOMER ACCEPTANCE
WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:
Boot system and monitor boot sequence for errors. Test functionality of system:
1. Run the Solaris "fmadm faulty" and SP/ILOM "show faulty" command (if only ALOM is supported run "showfaults -v" command) to verify that the fault has been cleared.
2. Perform one of the following tasks based on your verification results:
* If the previous steps did not clear the fault, refer to doc 1004229.1 for information about the tools and methods you can use to diagnose and clear
component faults.
* If the previous steps indicate that no faults have been detected, the component has been replaced successfully. No further action is required
3. Restart software applications per applicable administration guides to resume system operation.
PARTS NOTE:
https://support.oracle.com/handbook_private/Systems/SunBladeT6320/SunBladeT6320.html
REFERENCE INFORMATION:
SPARC T6320 Server Module Service Manual at http://docs.oracle.com/cd/E19745-01/820-2386-12/index.html
Attachments
This solution has no attachment