Asset ID: |
1-71-1458536.1 |
Update Date: | 2012-05-16 |
Keywords: | |
Solution Type
Technical Instruction Sure
Solution
1458536.1
:
How to Replace the Netra SPARC T3-1 or T4-1 DVD:ATR:1458536.1:1
Related Items |
- Netra T3-1
- Netra SPARC T4-1 Server
|
Related Categories |
- PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
|
Applies to:
Netra T3-1 - Version Not Applicable and later
Netra SPARC T4-1 Server - Version Not Applicable and later
Information in this document applies to any platform.
Goal
Service the DVD.
********************************************************************************
To report errors or request improvements on this procedure,
please go to http://support.us.oracle.com and put a comment on Doc ID: 1458536.1
********************************************************************************
Fix
DISPATCH INSTRUCTIONS
WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
Netra SPARC T3-1 or T4-1 Knowledge
TIME ESTIMATE: 20 minutes
TASK COMPLEXITY: 1
FIELD ENGINEER INSTRUCTIONS
PROBLEM OVERVIEW: DVD failure
WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :
Shut down system and Power down the server.
WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
A. Removing DVD drive
1. Remove the top cover.
2. Disconnect the two-wire cable from the DVD bracket
3. Raise the DVD cover
4. Lift the DVD drive out of the DVD bracket
5. Remove the cable from the rear of the DVD drive
B. Install DVD drive
1. If not done already, remove the two-wire cable from the DVD bracket and open the DVD cover.
2. Attach the cable to the rear of the DVD drive
3. Align the DVD drive to the location where it installs into the chassis. The slot of the DVD drive is toward the front of the chassis. The cable connector is to the left.
4. Lower the front of the DVD drive into the DVD bracket.
5. While lowering the rear of the DVD drive, slide it forward into the DVD bracket.
6. Close the DVD cover.
7. Attach the two-wire cable to the DVD bracket
8. Install the top cover.
OBTAIN CUSTOMER ACCEPTANCE
WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:
Turn on the system and verify functionality.
PARTS NOTE: 390-0486 [C] 8x SATA DVD-Writer/24x CD-Write (same part for both Netra T3-1 & T4-1)
REFERENCE INFORMATION: Netra SPARC T3-1 Service Manual, p/n E20693-xx or Netra SPARC T4-1 Service Manual, p/n E23206-xx
Attachments
This solution has no attachment