SPARC T4-1
 
Netra SPARC T4-1 Server
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
 

In this Document

Goal

Fix

Applies to:

Goal

Service a SPARC T4-1 / Netra T4-1 Rack Mount Kit without Tools

******************************************************************************
To report errors or request improvements on this procedure,
please go to http://support.us.oracle.com and put a comment on Doc ID: 1416038.1
******************************************************************************

Fix

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
No skills required, can be serviced by customer

Time Estimate: 60 minutes
Task Complexity: 0

FIELD ENGINEER INSTRUCTIONS

PROBLEM OVERVIEW: RACK MOUNT KIT - TOOL LESS REPLACEMENT

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? : N/A

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
Install the Snap-In Slide Rail Assemblies

1. Pull both mounting brackets completely out of their respective slide rails.
a. Simultaneously press and hold the upper and lower lock buttons of the slide rail lock.
b. Pull the mounting bracket out until it stops.
c. Slide the mounting bracket release button to the left, then slide the mounting bracket completely out of the slide rail.

2. Attach a mounting bracket to the right side of the server chassis.
a. Position the mounting bracket against the chassis. Ensure that the slide rail lock is at the front and the keyed openings on the mounting bracket are aligned with the locating pins on the side of the chassis.
b. Ensure that the heads of the four locating pins protrude through the keyed openings in the mounting bracket. Slide the mounting bracket toward the front of the chassis until the bracket locks into place with an audible click.
c. Verify that all four locating pins are trapped in the keyed openings and that the third locating pin from the front has engaged the mounting bracket lock.

3. Attach the second mounting bracket to the left side of the server chassis.

4. Orient the slide rails, ensuring that the ball bearing tracks (labeled FRONT) are forward.

5. Extend the slide rails (outer section) to fit the rack and attach the slide rails to the rack.
You hear an audible click when the rails securely attach to the rack.
Caution: Deploy the anti-tilt feature on the rack before continuing the installation.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:

PARTS NOTE:
https://support.oracle.com/handbook_private/Systems/SPARC_T4_1/components.html#Rack
https://support.us.oracle.com/handbook_internal/Systems/Netra_T4_1/components.html#Rack

REFERENCE INFORMATION:

SPARC T4-1:  http://docs.oracle.com/cd/E22985_01/index.html
Netra SPARC T4-1:  http://docs.oracle.com/cd/E23203_01/index.html

This solution has no attachment