SL3000 - Re-Enable ILC and Check ComplexId After FRS-3.0 Code Upgrade

Asset ID:	1-71-1361969.1
Update Date:	2011-09-27
Keywords:

Solution Type Technical Instruction Sure

Solution 1361969.1 : SL3000 - Re-Enable ILC and Check ComplexId After FRS-3.0 Code Upgrade

Applies to:

Sun StorageTek SL3000 Modular Library System - Version: Not Applicable and later [Release: N/A and later ]
Information in this document applies to any platform.

Goal

SL3000 - Re-Enable ILC and Check ComplexId After FRS-3.0 Code Upgrade
( Inner Library Communication )

Solution

After upgrading to FRS-3.0 code from older versions you need to check via the CLI that the ILC is still enabled and also check the setting of the complexId.
If you use SDP and/or use Port 1A for service, this is important to check.

Commands to check/set these values:

For COMPLEXID

config complexId print
Prints the current SDP complex ID

config complexId set [1-254]
Sets the complexId to the specific number for SDP (default is "1")

For ILC

config ilc print
prints ilc status

config ilc enable | disable
enable or disable the ilc

Provided by Rich Kent.

Attachments

This solution has no attachment