![]() | Sun System Handbook - ISO 4.1 October 2012 Internal/Partner Edition | ||
|
|
![]() |
||||||||||||
Solution Type Technical Instruction Sure Solution 1349691.1 : How to Remove and Replace a Ultra 24 Workstation System Fan:ATR:1349691.1:0
In this Document
Applies to:Sun Ultra 24 Workstation - Version: Not ApplicableInformation in this document applies to any platform. GoalHow to Remove and Replace a Ultra 24 Workstation System FanSolutionDISPATCH INSTRUCTIONS- WHAT SKILLS DOES THE ENGINEER NEED:Nothing beyond basic hardware and Solaris training - TIME ESTIMATE: 60 minutes - TASK COMPLEXITY: 0 FIELD ENGINEER INSTRUCTIONS: - PROBLEM OVERVIEW:How to Remove and Replace a Ultra 24 Workstation System Fan - WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?: - WHAT ACTION DOES THE ENGINEER NEED TO TAKE: 1. Powering Off the System and Removing the Left-Side Access Panel.I. Power off the system and all the peripherals connected to it.II. Turn the power switch on the back of the chassis to the Off position. caution icon Caution - Failure to properly turn off the system before you start installing components can cause serious component damage. III. To maintain system grounding, do not unplug the AC power cord from the back of the system unless the specific procedure instructs you to unplug it. IV. Loosen the two captive thumbscrews located on the rear edge of the left side access panel V. Slide the access panel approximately 1.5 cm toward the back of the workstation. VI. Tilt the top edge of the panel out, then lift the panel upward. VII. Carefully set the panel aside. Replace the System Fan2. Locate the system fan on the back inside panel of the workstation.3. Disconnect the system fans power connector from the SYS_FAN connector on the motherboard. To locate the SYS_FAN connector, refer to the service label on the left side access panel or to Internal Components and Connectors. 4. Release the fans power cord from the cable management strap. 5. Gently lift the two latches on the bottom of the fan bracket until the latches clear the chassis. 6. Slide the fan assembly down to release the four hooks on the back of the bracket from the holes in the chassis. 7. Pull the fan away from the chassis. 8. Remove the new fan from its package. 9. Locate the four corner holes in the chassis grill where the fan tabs are installed. 10. Gently press the fan against the chassis, with the four hooks on the back of the fan bracket in the corner holes on the chassis grill. 11. Slide the fan up until the latches click into their locked position. 12. Route the fans power cord through the cable management strap near the top right corner of the motherboard. 13. Connect the fan cable to the SYS_FAN connector on the motherboard. OBTAIN CUSTOMER ACCEPTANCE - WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:Nothing beyond basic hardware and Solaris training PARTS NOTE: REFERENCE INFORMATION: Sun Ultra 24 Workstation Service Manual http://download.oracle.com/docs/cd/E19127-01/ultra24.ws/820-2480-12/ Attachments This solution has no attachment |
||||||||||||
|