![]() | Sun System Handbook - ISO 4.1 October 2012 Internal/Partner Edition | ||
|
|
![]() |
||||||||||||
Solution Type Technical Instruction Sure Solution 1349655.1 : How to Remove and Replace an Ultra 20 Workstation DVD Drive:ATR:1349655.1:0
In this Document
Applies to:Sun Ultra 20 Workstation - Version: Not Applicable to Not Applicable - Release: N/A to N/AInformation in this document applies to any platform. GoalHow to remove and replace an Ultra 20 Workstation DVD DriveSolutionDISPATCH INSTRUCTIONS- WHAT SKILLS DOES THE ENGINEER NEED: - TIME ESTIMATE: 15 minutes - TASK COMPLEXITY: 0 FIELD ENGINEER INSTRUCTIONS: - PROBLEM OVERVIEW: Replacing / installing a DVD Drive - WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?: - WHAT ACTION DOES THE ENGINEER NEED TO TAKE: Remove 1. Remove any media in the DVD drive. 2. Turn off the power button on the back of the system and power off all of the peripherals connected to the workstation. 3. Remove the left-side access panel. 4. Remove the front bezel (see Section 4.3.2, Removing the Front Bezel). 5. Disconnect the cables from the back of the DVD drive. 6. Push the drive retaining lever tab up to release the lever from its retaining hooks (see FIGURE 4-10). 7. Gently pull out the DVD drive from the front of the chassis. 8. Place the DVD drive on a static-dissipating work surface or inside an anti-static bag. 9. Install the new DVD drive as shown in Section 4.5.3.2, Installing a DVD Drive. Install 1. Remove the DVD drive from its packaging. 2. Turn off the power button on the back panel and all of the peripherals connected to the workstation. 3. Remove the left-side access panel. 4. Slide the 5.25-inch drive with preinstalled carrier into the drive bay. Ensure that the holes in the drive case are aligned with the holes in the chassis drive bay, from which the drive retaining lever pin was withdrawn. 5. Lock the drive in the bay by rotating the drive retaining lever downward until the drive is captured by the retaining hooks. 6. Connect the IDE, power, and jumper cables to the back of the DVD drive (see FIGURE 4-12). Refer to the cabling diagram in the service label on the side of the chassis for information on correct cable routing. 7. Replace the front bezel and left-side cover of the workstation. OBTAIN CUSTOMER ACCEPTANCE - WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE: PARTS NOTE: REFERENCE INFORMATION: Sun Ultra 20 Workstation User Guide http://download.oracle.com/docs/cd/E19127-01/ultra20.ws/819-2146-13/index.html Attachments This solution has no attachment |
||||||||||||
|