Sun Microsystems, Inc.  Sun System Handbook - ISO 4.1 October 2012 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Asset ID: 1-71-1317984.1
Update Date:2011-11-10
Keywords:

Solution Type  Technical Instruction Sure

Solution  1317984.1 :   How to remove and replace an X4500 BATTERY:ATR:2025:0  


Related Items
  • Sun Fire X4500 Server
  •  
Related Categories
  • PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: x64-CAP VCAP
  •  




In this Document
  Goal
  Solution


Applies to:

Sun Fire X4500 Server - Version: Not Applicable and later   [Release: N/A and later ]
Information in this document applies to any platform.

Goal

How to remove and replace a X4500 BATTERY 

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?) This component is a CRU and can be replaced by anyone.

TIME ESTIMATE: 20 minutes

FIELD ENGINEER INSTRUCTIONS

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? : As usual, the best is when customer shuts down the OS.
Also in case we need to rack out the server, as usual, write down to a paper sheet a complete wiring diagram.

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:1. Power off the server

2. Remove the cable management arm.

See one of the following depending on your system:


Sun Cable Management Assembly Installation Guide for the Sun Fire X4540 Server
Sun X4500-J Slide Rail Installation Guide (X4500)
Early-Production Slide Rail and CMA Information (X4500)
3. Remove the system controller

4. Remove the battery by gently pulling the clip away from the battery face and lifting the battery straight up

Note: Observe the orientation (polarity) of the battery in its holder before it is removed. The positive polarity, marked with a "+" symbol, must face toward the side where the PCI slots are located.

5. To install a new battery, gently pull the clip away and insert.

Note: Install the new battery in the holder with the same orientation (polarity) as the battery that you removed.

6. In some cases for the battery to work, you might need to reset the CMOS on the I/O controller board.

To reset the CMOS, use a screwdriver to short the pins for one or two seconds on jumper J27 on the I/O controller board. Jumper J27 is near the serial connection to the service processor (labeled SER MGT) on the back of the server.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE: Login into ILOM via http or ssh access and validate the date and time. If incorrect, set from the ILOM

PARTS NOTE: N/A
REFERENCE INFORMATION:

See the section "To replace a battery in the

Sun Fire X4500/X4540 Server Service Manual
http://download.oracle.com/docs/cd/E19121-01/sf.x4500/819-4359-19/index.html



Attachments
This solution has no attachment
  Copyright © 2012 Sun Microsystems, Inc.  All rights reserved.
 Feedback