How to Remove and Replace a Sun Fire T2000 Power Cord Kit:ATR:1162:0

Asset ID:	1-71-1307436.1
Update Date:	2011-11-14
Keywords:

Solution Type Technical Instruction Sure

Solution 1307436.1 : How to Remove and Replace a Sun Fire T2000 Power Cord Kit:ATR:1162:0

Applies to:

Sun Fire T2000 Server - Version: Not Applicable and later [Release: N/A and later ]
Sun SPARC Enterprise T2000 Server - Version: Not Applicable and later [Release: N/A and later]
Information in this document applies to any platform.

Goal

How to Remove and Replace a Sun Fire T2000 Power Cord Kit

Solution

*DISPATCH INSTRUCTIONS*

WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
Basic Sun hardware FE skills

TIME ESTIMATE: 30 minutes

TASK COMPLEXITY: 0

*FIELD ENGINEER INSTRUCTIONS*

PROBLEM OVERVIEW:
T2000 Power Cord Kit replacement

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

Server has two power cords with dual power supply redundancy. The server can remain running if replacing only one power cord. If, not Customer should shut the operating system down gracefully (using "init 0"), and after the system has shut down run the following commands from the ALOM:
1. setlocator on
2. poweroff

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
Remove the power cable:
1. Verify the system has been shut down by the customer.
2. Replace power cable.OBTAIN CUSTOMER ACCEPTANCE

*OBTAIN CUSTOMER ACCEPTANCE*
WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:
Restart system and have the System administrator verify functionality of system.

PARTS NOTE:
None

REFERENCE INFORMATION:

Sun Fire T2000 Server Service Manual, p/n 819-2548

Sun SPARC Enterprise T2000 Server Service Manual, , p/n 819-7989

Attachments

This solution has no attachment