![]() | Sun System Handbook - ISO 4.1 October 2012 Internal/Partner Edition | ||
|
|
![]() |
||||||||||||
Solution Type Problem Resolution Sure Solution 1002463.1 : Sun Fire[TM] V480, V490, V880 and V890 system with RoHS RSC, part number 501-7314, emits "Unrecognized SC type, assuming 5016767" or give error "unable to find RSC serial device" while doing flashupgrade
PreviouslyPublishedAs 203436
Applies to:Sun Fire V480 ServerSun Fire V490 Server Sun Fire V880 Server Sun Fire V890 Server Sun Fire V880z Visualization Server All Platforms SymptomsSymptoms:Sun Fire[TM] V490 and V890 systems with a certain Remote System Control Board (RSC) installed and running RSC Software Version 2.2.3, will see messages on the RSC's serial or network console ports that are likely to cause concern or confusion. The following two examples show the messages seen - Example 1: The following message can be seen either when the RSC is rebooted or when the platform is powered on:
Note: It is not seen during a host reset: OCT 24 12:42:34 argualas: 00060004: "RSC Request to Reset Host." Example 2: The following failure message can been seen when performing an RSC Software update to Software version 2.2.3. This is using the RSC software command, rsc-config, to perform the Software update:
ChangesThese messages are specific to the Reduction of Hazardous Substances (RoHS) RSC Board, part number 501-7314., and the presence of RSC Software Version 2.2.3CauseThis issue is due to the part number in the RoHS RSC's SEEPROM being different to the non-RoHS RSC. RSC software version 2.2.3 originally had only part number 501-6767 defined in the list of known part numbers. The result is that the firmware calls out RoHS part number as being unrecognized. There are now patches available to resolve this issue. SolutionRelief/WorkaroundCustomers running Solaris 8 should apply patch: 119380-02 (or later) - RSC 2.2.3 bug fixes for Solaris 8 Customers running Solaris 9 or Solaris 10 should apply patch: 119381-02 (or later) - RSC 2.2.3 bug fixes for Solaris 9 and Solaris 10 Special Notes: If the replacement of the RSC card is required for whatever reasons, only replace RoHS RSC card with non-RoHS version in a non RoHS machine. DO NOT put a non-RoHS RSC card in a RoHS machine. If there is a RSC card replacement to a non-RoHS version, and if above error still occurs while doing flashupdate on non-ROHS card then do the following steps below: Try method A first. If method A is not successful, use method B. Method A: Reset rsc.
Method B: Reseat the RSC card and reflash the RSC card.
Previously Published As 86546 Attachments This solution has no attachment |
||||||||||||
|