SL500 - CAP Door Sticking and Hard to Open Latch

Asset ID:	1-72-1016168.1
Update Date:	2010-12-27
Keywords:

Solution Type Problem Resolution Sure

Solution 1016168.1 : SL500 - CAP Door Sticking and Hard to Open Latch

Applies to:

Sun StorageTek SL500 Modular Library System - Version: Not Applicable and later [Release: N/A and later]
All Platforms
Checked for relevance on 27-Dec-2010.

Symptoms

CAP latch sticking
Hard to push CAP handle
CAP door is difficult to open

Changes

{CHANGE}

Cause

Additional Information
The CAP has reverse logic:
Situation

The CAP has reverse logic or reverse from anything (STK) normally has do.

History

Typically the CAP would show connected so that if it were disconnected, there would be some sort of warning or logic state that would indicate it is unplugged or not hooked up.

SL500 CAP

Because other expansion modules may or may not be present, it was decided to reverse the logic of the CAP switch so if the other modules (& CAPs) were not present, there would be no complaints about them not being present to the RLC card.

With that said - with the CAP in the closed position - the switch is open - or just in its normally open state.

When the CAP is open, the switch is closed. If Open or if it has been jumpered at the switch or the connector, they are telling the unit the CAP door is open.

**** The unit will not initialize with the CAP door open. ****

One CAP latch problem that has been seem - CAP Stick and Door hard to open.

The latch for the CAP door is part of the front plate assembly. There have been a few latch parts that had some mold flash on them that made them stick and hard for the hand to push. You can open the door and operate the push latch by hand to determine if the latch is smooth in operation. If the door doesn't open or the latch is hard to push there is most likely a problem with the part keeping the hand from allowing the CAP to open.

You get the latch with a CAP door unless the entire assembly is ordered.

Solution

Resolution
If this problem is being experienced, a replacement CAP door with latch may be ordered.
This is for the Base Unit:
314575704 Door CAP Assy, STK SL500

This is for an Expansion Unit:
314503704 Door Assy, 8U, 2 CAP, STK SL500

Latch, SL500, CAP Door, There are a few latch parts that had mold flashing on them that made them stick and hard for the hand to push, CAP stuck, Hard to open
Previously Published As STKKB55104

Attachments

This solution has no attachment