Asset ID:	1-72-1015472.1
Update Date:	2011-05-06
Keywords:

---

Solution Type  Problem Resolution Sure

Solution  1015472.1 :   L180/L700 - Swap of LTO Drives Causes Loss of Dynamic WWN  


PreviouslyPublishedAs
223776

Applies to:

LTO Tape Drive - Version: Not Applicable and later    [Release: N/A and later]
Sun StorageTek L700 Tape Library - Version: Not Applicable and later    [Release: N/A and later]
Sun StorageTek L1400 Tape Library - Version: Not Applicable and later    [Release: N/A and later]
Sun StorageTek L180 Tape Library - Version: Not Applicable and later    [Release: N/A and later]
All Platforms
Checked for relevance on 6-May-2011.

Symptoms

Customer unable to see drive after swapping.
Unable to see drive after replacement.

Changes

{CHANGE}

Cause

{CAUSE}

Solution

Resolution
Use REVERT command under CLI interface to reset the Drive WWNs to Native before swapping drives.
Refer to Document: 1013289.1 for further information on this issue.



L700 changed from Native WWN to Dynamic WWN, L700, Dynamic world wide name, LTO Ultrium, LTO Ultrium Generation 2, L700e, L180, dWWN, Moved drives between slots, Swapped drive position
Previously Published As STKKB42426


Attachments

This solution has no attachment