Press Escape on the Operator Panel to display the optional menu selections. Press the down-arrow key to scroll to the System Sensors menu and press Enter to select the menu.

Press the arrow keys (up, down, right, left) to display the status of the System Sensors. Press Escape to return to the menu.

Press the arrow keys (up, down, right, left) to make selections. Press the Enter key to start the test. Press the Escape key to abort a diagnostic or to return to the menu.

Position to Elem

The CHM moves to the tape or drive position selected.

Position 0 = fixed magazine

Positions 1 - 10 = removable tape magazine

Position 82 = top tape drive

Position 83 = bottom tape drive

Park

The CHM moves to the Operator Panel side of the Long Axis and to the front of the Short Axis.

Move Cartridge

A tape moves from one position to another. This test does not move a tape from Position 82 or 83 if a tape is loaded inside the drive.

Scan

The Bar Code Scanner scans each tape position. Light is projected during the test.

Scan w/Range

The Bar Code Scanner scans the specified tape positions.

Home Gripper

The Gripper jaws are moved to the open position.

Home CHM

The CHM moves to the Tape Drive side of the Long Axis and to the front of the Short Axis.

Cycle Pick/Place

The CHM removes and replaces a tape from the position selected in increments of 10 passes. This test does not move a tape from Position 82 or 83 if a tape is loaded inside the drive.

Cycle Gripper

The Gripper jaws open and close in increments of 10 passes. The last pass leaves the jaws in the open position.

Cycle S Axis

The CHM travels the length of the Short Axis in increments of 10 passes.

Cycle L Axis

The CHM travels the length of the Long Axis in increments of 10 passes.

Cycle Solenoid

The door locking Solenoid is activated in increments of 10 passes.

Self Test

The Gripper moves to the home position.

The CHM moves to the home position.

The Short Axis cycles one time.

The Long Axis cycles one time.

Slot Demo

Tapes are randomly moved from Positions 0 - 10. The Magazine, a tape, and at least one empty slot is required. Press Escape to stop the Demo.

Drive Demo

Tapes are randomly moved from Positions 0 - 10 to the Tape Drives. The Magazine and a tape are required. Error 18 is displayed If the load cartridges in the drives? option is selected. The test will hang after one pass if the number of tapes is not greater than the number of tape drives. Press Escape to stop the Demo.