Netra[tm] t1 100/105 Servers: Repair Procedures
This section provides the most common repair procedures for the
Netra t1 100/105, which are included in the following manual:
 Netra
t1 User and Administration Guide (806-4707)
The following table provides the page numbers for
each procedure.
| Component |
Tips |
| CD-ROM Drive |
- Recovering from a Netra t1 CDROM Failure (Problem article 1008580.1).
|
| Memory Board |
- Netra t1 AC/DC systems supplied with 512MB of memory are now fitted
with two 256MB cards, rather than a single 512MB card (FIN I0772-1).
|
| Memory Boards (stack of four) |
- Netra t1 AC/DC systems supplied with 512MB of memory are now fitted
with two 256MB cards, rather than a single 512MB card (FIN I0772-1).
|
| Netra t1 100/105 (entire system) |
- This procedure provides instructions to replace an entire system,
because you can re-use the old system's MAC address and serial number
in the new system. This information is stored on the motherboard in
a removable component called the Host ID chip.
|
| PCI Card |
- If you are going to install an internal CD-ROM drive, do so before
you install the PCI card. Otherwise you will have to remove the PCI
card again.
- How do I install a PCI card in the Netra T1 105 (How To article 206423).
|
|
