Sun Microsystems, Inc.   Sun System Handbook - ISO 3.4 June 2011 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Netra[tm] st D130 Storage Array: Repair Procedures

This section provides the most common repair procedures for the Netra st D130. The written procedures below are located in the Netra st D130 Installation and Maintenance Manual (806-1489).

Component Tips
Disk Drive
  • Clustered Netra D130 array causes various SCSI errors under load if LVD SCSI Disk Drives are installed to replace failed single ended SCSI disk drives in a cross cabled configuration. (FIN I1144-1).
  • If you remove a disk drive, you must fill the slot with a foam filler so the unit will cool properly.
  • Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (FIN I1136-1).
  • 18.2GB and 36GB IBM disk drives may be susceptible to early life failures problem (I0724-2).
  • Seagate Cheetah 7 FC-AL and SCSI disk drives with serial numbers below 60000 are experiencing a higher than expected failure rate due to a spindle motor issue (FCO A0239-1).
  • Seagate 4 FCAL and SCSI Disk Drives may experience higher than expected failure rates (FCO A0222-1).

  Copyright © 2011 Sun Microsystems, Inc.  All rights reserved.
 Feedback