Technical support is supplied by ATL/Quantum in EMEA and the Americas; Sun provides support in all other locations.
This section provides the most common repair procedures for the L1000. The
repair procedures are provided in the following manual:
The table below provides the page numbers that each procedure begins on.
|
Component
|
Page Numbers
|
Tips
|
|
Removing the Enclosure
|
6-3
|
|
|
Securing the X-Chassis in the Maintenance Position
|
6-4 - 6-5
|
When the x-chassis is in a raised position, and the left
side y-axis belt is removed, (disengaging the y-axis motor) the x-chassis
must be secured in its raised position or it will slam to the base of
the cabinet.
|
|
Removing Y-Axis Stepper Motor
|
6-6 - 6-7
|
|
|
Removing X-Axis Stepper Motor
|
6-8 - 6-9
|
|
|
Removing Power Supply
|
6-10 - 6-11
|
|
|
Removing X-Axis Timing Belt
|
6-12 - 6-13
|
|
|
Removing Power Switch
|
6-14 - 6-15
|
|
|
Removing Single & Double Fan Bracket Assemblies
|
6-16 - 6-17
|
|
|
Removing 41 CFM Fan
|
6-18 - 6-19
|
|
|
Removing 90 CFM Fan
|
6-20 - 6-21
|
|
|
Removing Differential Wide SCSI PWA
|
6-22 - 6-23
|
|
|
Removing Y-Axis Timing Belt
|
6-24 - 6-27
|
|
|
Removing Right Door Assembly with Control Panel Display
|
6-28 - 6-29
|
|
|
Removing DLT7000 Differential Tape Drive
|
6-30 - 6-31
|
|
|
Removing Robotics Controller PWA
|
6-32 - 6-33
|
|
| Removing Actuator PWA
|
6-34 - 6-35
|
|
|
Removing Passive Backplane PWA
|
6-36 - 6-37
|
|
|
Removing Y-Encoder Interconnect PWA
|
6-38 - 6-39
|
|
|
Removing X-Motor Interconnect PWA
|
6-40 - 6-41
|
|
|
Removing Extension / Rotary Assembly
|
6-42 - 6-43
|
|
|
Removing Load Pack Assembly
|
6-44 - 6-45
|
|
|
Removing Left Door
|
6-46 - 6-47
|
|
