PCI Dual Ultra-3 SCSI Host Adapter
Option 6758
375-3057 |
QLogic QLA10162/66-SUN 3.3/5V 32/64Bit 33/66MHz |
Qualified SCSI Cables for Array Connections
StorEdge 3310 and D2 |
Type |
Length |
Mktg Part # |
Mfg Part # |
VHDCI-VHDCI |
0.8 m |
X1136A |
530-2982 |
VHDCI-VHDCI |
1.2 m |
X1137A |
530-2983 |
VHDCI-VHDCI |
2 m |
X1138A |
530-2538 |
VHDCI-VHDCI |
4 m |
X3830B |
530-2984 |
VHDCI-VHDCI |
10 m |
X3831B |
530-2985 |
StorEdge S1 |
Type |
Length |
Mktg Part # |
Mfg Part # |
HD68-VHDCI |
0.8 m |
X1132A |
530-2452 |
HD68-VHDCI |
2 m |
X3832A |
530-2453 |
HD68-VHDCI |
4 m |
X3830A |
530-2454 |
HD68-VHDCI |
10 m |
X3831A |
530-2455 |
Notes
- The minimum operating system is Solaris 8 with the
Recommended Patch Cluster.
- The necessary drivers (SUNWqus & SUNWqusu for 32-bit
and 64-bit configurations, and SUNWqusx & SUNWqusux
for 64-bit configurations) and patches for this product
are not included in Solaris 8 or 9, but must be downloaded.
Please see the Release Notes,
816-2157,
for downloading details.
- When using 375-3057 in a multi-initiator configuration with shared
StorEdge 3310 or S1 arrays, the jumpers on the board for the
appropriate shared SCSI bus must be set to "manual SCSI termination".
- The jumpers for Port 2 are set to manual termination by factory
default:
(J4 and J5 = 2-3)
- Prior to May 2003, the factory default of Port 1 was automatic SCSI
termination:
(J8 and J9 = 1-2)
If Port 1 is shared, these jumpers must be changed to manual
termination:
(J8 and J9 = 2-3)
This became the default setting of J8 and J9 in May 2003.
(see ECO WO_26435)
For details, see BugID 4836405.
- Qualification on Sun Blade 1000 and 2000 is documented in BugID 4644090.
Reference
-
StorEdge PCI Dual Ultra3 SCSI Host Adapter Installation Guide, 816-2156.
-
StorEdge PCI Dual Ultra3 SCSI Host Adapter Release Notes, 816-2157.
|