Sun Blade[tm] 100 Workstation: Repair Procedures

This section provides the most common repair procedures for the Sun Blade 100 workstation. The written procedures below are links to the Sun Blade 100 Service Manual (806-3416).

Component	Remove	Install	Tips
CD-ROM Drive	X	X
DVD-ROM Drive	X	X
CPU Module	X	X
Disk Drive (Primary)	X	X	Installation of a Seagate ST320011A HDD into the drive tray of a Sun Blade 100 will unseat the hard drive tray latch cover (FIN I0787-1). New 20.1GB disk drive is being released in a limited number of Sun Blade 100 systems (FIN I0872-1). Mirrored 20GB disk drives on Ultra 10 and Sun Blade 100 systems may be exposed to a drive compatibility issue when replacing a failed drive ( FCO A0202-1).
Disk Drive (Secondary)		X	Installation of a Seagate ST320011A HDD into the drive tray of a Sun Blade 100 will unseat the hard drive tray latch cover (FIN I0787-1). New 20.1GB disk drive is being released in a limited number of Sun Blade 100 systems (FIN I0872-1). Mirrored 20GB disk drives on Ultra 10 and Sun Blade 100 systems may be exposed to a drive compatibility issue when replacing a failed drive ( FCO A0202-1).
Fan Assembly	X	X
Floppy Drive	X	X
Memory	X	X	When an ECC error occurs on Sun Blade 100, Solaris incorrectly identifies the faulty DIMM (FIN I0798-1). Idle Sun Blade 100 systems may experience unscheduled reboots (FCO A0205-1).
NVRAM/TOD	X	X
PCI Card	X	X	The SunPCi II board may not seat properly in the Sun Blade 100 chassis (FIN I0739-1). SunPCi II and SunPCi IIpro cards may not respond after rapid/successive power cycling (FCO A0186-1).
Power Supply	X	X
Riser Board	X	X
Smart Card Reader	X	X	Solaris 8 patches required for Smart Card Reader operation on Sun Blade 100, 1000, and 2000 systems (FIN I0868-1).
Speaker Assembly	X	X
System Board	X	X	New system boards with part number 375-3106 require special patches. Refer to the Sun Blade 100 Motherboard Update and Sun PGX64 Patch Procedures, 816-7660. New Motherboard FRU for Sun Blade 100 systems requires modified installation procedure (FIN I0843-1). 'prtconf' command may return wrong System Board part number on Sun Blade 100 systems (FIN I0923-1). SunBlade 100 systems may not auto-restart after a power failure (FCO A0204-1).