| Processor |
| Number |
One to 14 |
| Architecture |
167MHZ UltraSPARC[tm]; 250MHz, 336 MHz, 400 MHz, or 464 MHz UltraSPARC
II |
| Cache per processor |
Primary: 16-KB instruction, and 16-KB data on chip
Secondary: Up to 8-MB external cache |
| CPU interface |
One to 14, 128-bit Ultra Port Architecture (UPA) slots |
| System Interconnect |
Gigaplane, 2.68 GB/sec (at 84 MHz), 3.2 GB/sec (at 100 MHz) |
| System
Boards |
| Number of boards |
Maximum of eight boards per system (seven CPU/Memory boards, one I/O
board)
Minimum configuration requires one CPU/Memory board and one I/O board
|
| CPU/Memory board |
Holds up to two processors and 16 memory SIMMs |
| SBus I/O board |
Offers two SBus channels, three SBus slots, SunFastEthernet[tm], fast/wide
SCSI-2, two FC-AL sockets |
| Graphics I/O board |
Offers one SBus channel, two SBus slots, one UPA slot for Creator and
Creator3D graphics, SunFastEthernet, fast/wide SCSI-2, two FC-AL sockets |
| PCI I/O board |
Offers four PCI channels, two (short) PCI slots, SunFastEthernet, fast/wide
SCSI-2 |
| Main
Memory |
|
64-MB to 4-GB memory capacity per CPU/Memory board
Up to 2-GB memory expansion options (each a group of 8 SIMMs)
|
| Standard
Interfaces |
| Ethernet |
One ethernet/fast ethernet (10BASE-T/100BASE-T) twisted-pair standard
connector (RJ-45)
One MII for external
transceiver connection (available only on SBus and Graphics I/O boards) |
| FC-AL |
Two on-board sockets for GBIC modules (100 MB/sec, full duplex) supporting
Fibre Channel Arbitrated Loop (FC-AL) (available only on SBus and Graphics
I/O boards) |
| Keyboard and mouse |
One standard keyboard/mouse port (mini
DIN-8) on clock board |
| PCI |
Two PCI short slots per PCI I/O board operating at 33- or 66-MHz, 32-
or 64-bit data bus width, 3.3 or 5 volts (Note: Install appropriate voltage
riser card in slot before installing PCI card.) |
| SBus |
Three slots operating at 25-MHz, 64-bit data bus width |
| Serial |
Two RS-232C/RS423 serial ports (DB25)
on clock board |
| SCSI |
One 20-MB/sec, 68-pin,
fast/wide SCSI-2 (synchronous) per I/O board |
| Internal
Mass Storage |
| Internal disk |
Up to four disk boards, each with two 4.2-, 8.4-, 18.2, or 36.4-GB disks
|
| Internal tape |
8mm, 4mm, and 1/4" tape options available |
| CD-ROM/DVD-ROM |
SunCD[tm] 32 drive standard (last order December 2000)
10X DVD-ROM drive standard (capable of reading CD-ROM media only)
|
| Power
Supplies |
| One 184-watt Peripheral Power Supply standard. Up to four
hot swappable 300-watt Power Cooling Modules (PCM) with redundant, dual-speed
fans. One PCM required per two systems boards. Fully-redundant power and
cooling available on this system. |
| Environment |
| AC input |
100 - 240 VAC, 47 - 63 Hz, 12 A(max) |
| Input power |
1370 W |
| Heat output |
4680 BTU/hr |
| Temperature1 |
Operating: 5° C to 40° C (41° F to 104° F)
Nonoperating: -20° C to 60° C (-4° F to 140° F) |
| Humidity |
Operating: 20% to 80% relative humidity, noncondensing
Nonoperating: 5% to 93% relative humidity, noncondensing |
| Altitude |
Operating: 3000 m (10,000 ft.)
Nonoperating: 12,000 m (40,000 ft.) |
| Number of cords |
1 |
| Plug type - U.S. |
NEMA 5-15P |
| Plug type - International |
IEC 320, 10 A, 220 - 240 VAC |
| 1 Maximum operating
temperature is 35°C (95°F) when using tape media. |
Regulations
Meets or exceeds the following requirements: |
| Safety |
UL 1950, CSA 950, TUV EN60950, CB Scheme (Nordic Deviation) |
| RFI/EMI |
FCC Class A, DOC Class A, EN55022 Class A, VCCI Class 1 |
| Immunity |
EN50082-1 |
| Harmonics |
EN61000-3-2 |
| Dimensions
and Weights |
| Height |
34 cm (13.5 in.)
48 cm (19.0 in.) shipping |
| Width |
50 cm (19.7 in.)
60 cm (23.8 in.) shipping |
| Depth |
56 cm (22 in.)
68 cm (26.8 in.) shipping |
| Weight |
68 kg (150 lb.) approximate
72 kg (160 lb.) approximate shipping |
| Power Cord |
1.83 m (6 ft.) |
| Clearance
and Service Access |
| Front |
47 cm (18 in.) |
| Rear |
47 cm (18 in.) |
| Right1 |
16 cm (6 in.) |
| Left1 |
16 cm (6 in.) |
| 1 Although 16 cm
(6 in.) clearance is sufficient to prevent blocking the in and out airflow
of a single system, to avoid exhaust air recirculation, a minimum space
of 92 cm (36 in.) is recommended between systems sitting side by side. |
